这里有A-Z的单词很多：-/thread-7798-1-html再给你些句型：Carry out drilling operation in accordance with the drilling 按钻井程序进行钻井/作业Prepared bell 准备”喇叭口”短节Make up 2 joints of drill 接两根钻杆Break out this 卸开该接头Run hole opener to sea 下扩眼器到海底Mix gel fluid for drilling conductor 为钻导管井眼配制高粘度泥浆Make up bottom hole 组合下部钻具Check and reset crown-saver on every 每个班都要检查并重新调整天车防碰装置Number stands on trip out and trip 起下钻时给立柱编号Pick up BHA and run to 将下部钻具下到海底Pick up 接立柱Don’t drill faster than 15 minutes for 1 钻进速度别超过15分钟1根立柱Drop TOTCO 投(陶特)测斜仪Fish TOTCO with 用打捞筒捞起测斜仪Resume drilling to TD 继续钻进到总深Circulate 15 循环15分钟Run in 下钻Put out of 起钻Make an inventory of all ring 开一个所有垫圈的清单Use spinning 使用气动扳手Operate the air 操作气动绞车Lay down 57 joints of 5” drill 甩57根钻杆Pick up drill stem test 提起钻杆测试工具Circulate mud for 2 循环泥浆2小时Move string during 在循环时注意活动钻具Circulate hole 循环清洗井眼Circulate bottoms 循环泥浆几周Fill up every 5 每5柱灌泥浆一次Check mud weight every 15 每15分钟检查泥浆比重Reverse out excess 反循环替出多余的泥浆Change/replace old mud by new 用新的泥浆替换出旧的泥浆Stop 停止钻进Drilling 钻进Pull out of hole 起出钻头Change 换钻头Run the wear 下抗磨补心The bit thread type is regular 钻头丝扣是正规公扣What’s the make-up torque? 上扣扭矩要多大?你忘能对你有帮助。
